INSTALLATION INSTRUCTIONS 94-97 HONDA ACCORD BIG MOUTH BODYKIT

CLEANING PROCEDURE
USING A PAPER TOWEL AND GREASE REMOVER OR LACQUER THINNER, THOROUGHLY CLEAN AREA ON CAR WHERE THE DOUBLE FACE
TAPE WILL COME IN CONTACT WITH THE PAINTED SURFACE. DO NOT ALLOW THINNER OR CLOTH TO REMAIN ON CAR TOO LONG AS IT CAN
CAUSE DAMAGE TO THE PAINTED SURFACE. USING EITHER OF THE RECOMMENDED ADHESION PROMOTERS ON A CLEAN LINT FREE
CLOTH, APPLY A THIN, UNIFORM COATING TO THE BONDING SURFACE, USING THE MINIMUM AMOUNT THAT WILL FULLY COAT THE SURFACE.
ALLOW PROMOTER TO DRY COMPLETELY BEFORE ATTEMPTING INSTALLATION OF THE PART.

1) FRONT BIG MOUTH BUMPER COVER
REMOVE THE FACTORY BUMPER FASCIA AND TRIM PANEL THAT IS LOCATED ABOVE THE BUMPER. SAVE ALL
THE HARDWARE FOR LATER USE. REMOVE THE TURN SIG-
NAL MARKER LIGHTS FROM THE ORIGINAL FACTORY
BUMPER. USING THE FACTORY BUMPER AS A GUIDE DRILL
HOLES IN THE BIGMOUTH BUMPER. CHECK FIT THE BIG
MOUTH BUMPER COVER ON THE CAR. USING ALL THE FAC-
TORY HARDWARE SECURE THE WING WEST BUMPER TO
THE CAR.

DOWNLOAD